Back Door Lock (For Double Swing Out Type) -- Installation |
| 1. INSTALL BACK DOOR LOCK ASSEMBLY |
Apply MP grease to the sliding parts of the back door lock assembly.
Using a T30 "TORX" socket wrench, install the back door lock assembly with the 4 screws.
- Torque:
- 5.0 N*m{51 kgf*cm, 44 in.*lbf}
 |
Connect the 2 connectors.
Connect the back door lock cable assembly to the back door remote control assembly.
 |
Connect the back door lock locking link to the back door lock control assembly and rotate the snap as shown in the illustration.
Text in Illustration *1 Snap *2 Back Door Lock Locking Link *3 Back Door Lock Control Assembly *4 Back Door Remote Control Assembly *5 Back Door Lock Cable Assembly
| 2. INSTALL BACK DOOR SERVICE HOLE COVER LH |
Apply new butyl tape to the back door panel.
Pass the 2 links and wire harness through a new back door service hole cover, and then install the back door service hole cover using the reference points on the back door panel.
Text in Illustration *a Reference Point
 |
Attach the 3 clamps and connect the 2 connectors.
| 3. INSTALL BACK DOOR INSIDE HANDLE ASSEMBLY LH |
Connect the 2 links to the back door inside handle.
Attach the guide in the direction indicated by the arrow in the illustration to install the back door inside handle.
 |
Install the screw.
| 4. INSTALL REAR ASSIST GRIP REINFORCEMENT LH |
Install the rear assist grip reinforcement with the 3 bolts.
| 5. INSTALL BACK DOOR TRIM PANEL ASSEMBLY LH |
Attach the 10 clips to install the back door trim panel.
| 6. INSTALL DOOR INSIDE HANDLE BEZEL LH |
Attach the guide in the direction indicated by the arrow in the illustration, and then attach the 2 claws to install the door inside handle bezel.
 |
Install the screw.
Attach the claw to close the cover.
| 7. INSTALL ASSIST GRIP LH |
Install the assist grip with the 2 bolts.
Attach the 2 claws to close the 2 covers.