Generator (For 130 A, 150 A Type) Installation

Install the stud bolt.

Torque:

10 N*m{102 kgf*cm, 7 ft.*lbf}

Install the generator with the 3 bolts and nut.

Torque:

43 N*m{438 kgf*cm, 32 ft.*lbf}

Connect the harness bracket to the generator with the bolt.

Torque:

31 N*m{316 kgf*cm, 23 ft.*lbf}

Connect the generator wire with the nut.

Torque:

9.8 N*m{100 kgf*cm, 87 in.*lbf}

Close the terminal cap.

Connect the generator connector.

Connect the oil cooler tube with the 2 bolts.

Torque:

14 N*m{143 kgf*cm, 10 ft.*lbf}

Connect the vane pump to the timing chain cover with the 2 bolts.

Torque:

21 N*m{214 kgf*cm, 15 ft.*lbf}

Install the air cleaner cap and hose, and then tighten the hose clamp.

Torque:

2.5 N*m{25 kgf*cm, 22 in.*lbf}

Attach the 4 clamps.

Connect the mass air flow meter connector and attach the clamp.

Connect the No. 2 PCV hose and No. 1 air hose.

Install the front fender apron trim packing A with the 3 clips.

Set the fan and generator V belt onto every part.

While turning the belt tensioner counterclockwise, remove the pin.

NOTICE:

Make sure that the fan and generator V belt is properly set on each pulley.

Check that the belt fits properly in the ribbed grooves.

HINT:

Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

Install the No. 1 engine under cover sub-assembly with the 10 bolts.

Torque:

29 N*m{296 kgf*cm, 21 ft.*lbf}

Push in the clip to install the front fender splash shield sub-assembly LH.

Install the 3 bolts and screw.

Push in the clip to install the front fender splash shield sub-assembly RH.

Install the 3 bolts and 2 screws.

Attach the 2 V-bank cover hooks to the bracket. Then align the 3 V-bank cover grommets with the 3 pins, and press down on the V-bank cover to attach the pins.