Television Camera (For Side) Installation

Audio Visual Telematics. Land Cruiser. Urj200, 202 Grj200 Vdj200
Park Assist Monitoring. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. INSTALL SIDE TELEVISION CAMERA ASSEMBLY

  2. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH

  3. INSTALL OUTER MIRROR COVER LH

  4. INSTALL OUTER MIRROR LH

  5. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

  6. ADJUST SIDE TELEVISION CAMERA ASSEMBLY

Television Camera (For Side) -- Installation


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.


1. INSTALL SIDE TELEVISION CAMERA ASSEMBLY
  1. Install the side television camera with the 3 screws.

  1. Connect the connector.

  1. Install the body

    1. Attach the 2 guides and body.

      NOTICE:
      Be careful not to break the guide.
  1. Install the body cover

    1. Install the body with the 5 screws.



    Land Cruiser. Urj200, 202 Grj200 Vdj200
  1. Connect the connector.

  1. Attach the connector to the wire clip.

  1. Install the base

    1. Attach the guide.

    2. Using "TORX" socket wrench T25, install the base with 3 new screws.

      NOTICE:
      When installing the base, check that the wire harness is not caught between the base and housing. Failure to do so may cause a short circuit.
  1. Install the lower mirror cover

    1. Attach the 4 claws and install the new lower mirror cover.



  1. Install the gasket

    1. Attach the 9 guides and install the gasket.



    2. Land Cruiser. Urj200, 202 Grj200 Vdj200.Park Assist Monitoring.Toyota Parking Assist-Sensor System.Television Camera (For Side)  Installation
    3. Align the marking on the wire harness with the marking on the end of the wire harness insertion hole of the gasket as shown in the illustration, and wrap them with new vinyl tape starting from the gasket marking.

      Text in Illustration
      *1
      New Vinyl Tape
      *a
      Marking
      Standard:
      Area
      Specified Condition
      a
      50.0 mm (1.97 in.)
      NOTICE:
      If the vinyl tape is wrinkled, water may run down the wire harness and enter the vehicle. Make sure to wind the vinyl tape properly.


    4. Land Cruiser. Urj200, 202 Grj200 Vdj200.Park Assist Monitoring.Toyota Parking Assist-Sensor System.Television Camera (For Side)  Installation
    5. Wrap new vinyl tape as shown in the illustration.

      Text in Illustration
      *1
      New Vinyl Tape
      Standard:
      Area
      Specified Condition
      a
      30.0 mm (1.18 in.)
      b
      50.0 mm (1.97 in.)


2. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH
  1. Connect the connector.

  1. Install the light with the 3 screws.



3. INSTALL OUTER MIRROR COVER LH


  1. Install the outer mirror cover.



      Land Cruiser. Urj200, 202 Grj200 Vdj200.Park Assist Monitoring.Toyota Parking Assist-Sensor System.Television Camera (For Side)  Installation
    1. Insert the rib on the outer edge of the cover into the groove of the mirror body.

      NOTICE:
      Do not scratch the turn light.
      Text in Illustration
      *1
      Rib


    2. Land Cruiser. Urj200, 202 Grj200 Vdj200
    3. While making sure that the rib of the cover fits properly into the groove of the mirror body, squeeze the inner end of the cover and the mirror body together to attach the inner claws.



    Land Cruiser. Urj200, 202 Grj200 Vdj200
  1. Push on the cover at the locations of the 8 claws to confirm that the claws are attached properly.

  1. Check that there is no gap between the cover and mirror body.

    HINT:
    If there is a gap between the cover and body, noise will occur during driving.


4. INSTALL OUTER MIRROR LH


Land Cruiser. Urj200, 202 Grj200 Vdj200
  1. w/ EC Mirror:
    Connect the connector.



    Land Cruiser. Urj200, 202 Grj200 Vdj200
  1. w/ Mirror Heater:
    Connect the 2 connectors.



    Land Cruiser. Urj200, 202 Grj200 Vdj200
  1. Attach the 4 claws to install the outer mirror LH.



5. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
(Click here)


6. ADJUST SIDE TELEVISION CAMERA ASSEMBLY
(Click here