Dtc C1625 Open Or Short In Steering Angle Sensor +B

Audio Visual Telematics. Land Cruiser. Urj200, 202 Grj200 Vdj200
Park Assist Monitoring. Land Cruiser. Urj200, 202 Grj200 Vdj200

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK HARNESS AND CONNECTOR (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY - BATTERY AND BODY GROUND)

DTC C1625 Open or Short in Steering Angle Sensor +B


DESCRIPTION

This DTC is stored if the parking assist ECU receives a signal via CAN communication from the steering sensor that indicates a power supply system problem.

DTC Code
DTC Detection Condition
Trouble Area
C1625
Open or short in steering angle sensor +B
  1. Harness or connector
  2. Spiral with sensor cable sub-assembly

WIRING DIAGRAM


Land Cruiser. Urj200, 202 Grj200 Vdj200.Park Assist Monitoring.Toyota Parking Assist-Sensor System. Dtc C1625 Open Or Short In Steering Angle Sensor +B


INSPECTION PROCEDURE

NOTICE:
  1. When "!" mark is displayed on the multi-display after the battery terminal disconnected, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed (Click here).
  3. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  4. The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags.
    Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System (Click here).
  5. The multi-terrain monitor system troubleshooting procedure is based on the premise that the VGRS system is operating normally. Check the VGRS system first before troubleshooting the multi-terrain monitor system (Click here).
1.CHECK HARNESS AND CONNECTOR (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY - BATTERY AND BODY GROUND)


    Land Cruiser. Urj200, 202 Grj200 Vdj200.Park Assist Monitoring.Toyota Parking Assist-Sensor System. Dtc C1625 Open Or Short In Steering Angle Sensor +B

  1. Disconnect the spiral with sensor cable sub-assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    E163-1 (ESS) - Body ground
    		Always
    		Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    		Condition
    		Specified Condition
    E163-4 (IG) - E163-1 (ESS)
    		Engine switch on (IG)
    		11 to 14 V
    E163-5 (BAT) - E163-1 (ESS)
    		Always
    		11 to 14 V
    Text in Illustration
    *a
    		Front view of wire harness connector
    (to Spiral with sensor cable sub-assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY (Click here)