Multi-Terrain Monitor System How To Proceed With Troubleshooting

Audio Visual Telematics. Land Cruiser. Urj200, 202 Grj200 Vdj200
Park Assist Monitoring. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. VEHICLE BROUGHT TO WORKSHOP

  2. INSPECT BATTERY VOLTAGE

  3. CHECK AUDIO AND VISUAL SYSTEM

  4. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

  5. CHECK FOR DTC*

  6. PROBLEM SYMPTOMS TABLE

  7. OVERALL ANALYSIS AND TROUBLESHOOTING*

  8. ADJUST, REPAIR OR REPLACE

  9. CONFIRMATION TEST

Multi-Terrain Monitor System -- How To Proceed With Troubleshooting


HINT:
  1. Use the following procedure to troubleshoot the multi-terrain monitor system.
  2. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

    1. Measure the battery voltage with the engine switch off.

      Standard voltage:
      11 to 14 V
      If the voltage is below 11 V, replace or recharge the battery before proceeding.

    NEXT


    3.CHECK AUDIO AND VISUAL SYSTEM

    1. Refer to the audio and visual system.

      1. for Multi-media Module Receiver Type: Click here
      2. for Radio and Display Type: Click here
      Result
      Result
      		Proceed to
      Audio and visual system is normal
      		A
      Audio and visual system is abnormal (for Multi-media Module Receiver Type)
      		B
      Audio and visual system is abnormal (for Radio and Display Type)
      		C


    		B.
    GO TO AUDIO AND VISUAL SYSTEM (Click here)

    		C.
    GOT TO AUDIO AND VISUAL SYSTEM (Click here)
    A


    4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

    1. Use the GTS to check if the CAN communication system is functioning normally.

      1. for LHD with Central Gateway ECU: Click here
      2. for RHD with Central Gateway ECU: Click here
      Result
      Result
      		Proceed to
      CAN DTC is not output
      		A
      CAN DTC is output (for LHD with Central Gateway ECU)
      		B
      CAN DTC is output (for RHD with Central Gateway ECU)
      		B


    		B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)

    		C.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK FOR DTC*

    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTC (Click here).

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Result
      Result
      		Proceed to
      DTC is not output
      		A
      DTC is output
      		B



    		B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    6.PROBLEM SYMPTOMS TABLE

    1. Refer to the Problem Symptoms Table (Click here).

      Result
      Result
      		Proceed to
      Fault is not listed in Problem Symptoms Table
      		A
      Fault is listed in Problem Symptoms Table
      		B



    		B.
    ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
    A


    7.OVERALL ANALYSIS AND TROUBLESHOOTING*

    1. Data List / Active Test (Click here).

    2. Terminals of ECU (Click here).


    NEXT


    8.ADJUST, REPAIR OR REPLACE

      NEXT


      9.CONFIRMATION TEST

        NEXT

        END