Dtc C1694 Steering Angle Initialization Incomplete

Audio Visual Telematics. Land Cruiser. Urj200, 202 Grj200 Vdj200
Park Assist Monitoring. Land Cruiser. Urj200, 202 Grj200 Vdj200

SYSTEM DESCRIPTION

INSPECTION PROCEDURE

PERFORM SETTINGS

CHECK DTC OUTPUT

DTC C1694 Steering Angle Initialization Incomplete


SYSTEM DESCRIPTION

This DTC is stored when the multi-media module receiver assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).

DTC Code
DTC Detection Condition
Trouble Area
C1694
Maximum steering angle has not been memorized
  1. Steering angle setting
  2. Multi-media module receiver assembly

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the multi-media module receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/o Side Monitor System) may be needed (Click here).
1.PERFORM SETTINGS

  1. Perform the following to steering angle setting into the multi-media module receiver assembly.

    1. Refer to steering angle setting (Click here).


NEXT


2.CHECK DTC OUTPUT

  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC is not output.
    HINT:
    1. If DTC C1694 is output, perform the steering angle setting again.
    2. If DTC C1694 is still output after performing the steering angle setting 3 times, replace the multi-media module receiver assembly.


NG
REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY (Click here)
OK

END (STEERING ANGLE SETTING IS DEFECTIVE)