Rear Lower Arm Removal

Suspension. Land Cruiser. Urj200, 202 Grj200 Vdj200
Rear Suspension. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

  2. OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

  3. REMOVE REAR WHEEL

  4. SUPPORT REAR AXLE HOUSING ASSEMBLY

  5. REMOVE LOWER CONTROL ARM ASSEMBLY LH

Rear Lower Arm -- Removal


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Detach the clamp, and disconnect the connector from the protector.

  1. Remove the 3 bolts and protector.



2. OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)


  1. Using a 5 mm hexagon socket wrench, loosen the lower and upper chamber shutter valves of the stabilizer control with accumulator housing 2.0 to 3.5 turns.


    Land Cruiser. Urj200, 202 Grj200 Vdj200.Rear Suspension.Rear Suspension System.Rear Lower Arm Removal

    NOTICE:
    1. When loosening a shutter valve, make sure that the end protrudes 2 to 3.5 mm (0.0787 to 0.137 in.) from the surface of the block, and do not turn the shutter valve any further.
    2. Do not remove the shutter valves.


3. REMOVE REAR WHEEL


4. SUPPORT REAR AXLE HOUSING ASSEMBLY


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Support the rear axle housing with a jack using a wooden block to avoid damage.



5. REMOVE LOWER CONTROL ARM ASSEMBLY LH


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Remove the 2 nuts, 2 washers, 2 bolts and lower control arm.