Relay On-Vehicle Inspection

Suspension. Land Cruiser. Urj200, 202 Grj200 Vdj200
Suspension Control. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE SUSPENSION CONTROL RELAY

  3. INSPECT SUSPENSION CONTROL RELAY (AHC)

  4. INSTALL SUSPENSION CONTROL RELAY

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Relay -- On-Vehicle Inspection



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE SUSPENSION CONTROL RELAY

  1. Remove the suspension control relay from the engine room relay block.



3. INSPECT SUSPENSION CONTROL RELAY (AHC)


    Land Cruiser. Urj200, 202 Grj200 Vdj200.Suspension Control.Suspension Control System.Relay On-Vehicle Inspection

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    3 - 5
    		Battery voltage is not applied to terminals 1 and 2
    		10 kΩ or higher
    Battery voltage is applied to terminals 1 and 2
    		Below 1 Ω
    1. If the result is not as specified, replace the suspension control relay.


4. INSTALL SUSPENSION CONTROL RELAY

  1. Install the relay to the engine room relay block.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).