Drivetrain. Land Cruiser. Urj200, 202 Grj200 Vdj200
Drive Shaft Propeller Shaft. Land Cruiser. Urj200, 202 Grj200 Vdj200
Front Propeller Shaft Assembly -- Disassembly |
- NOTICE:
- Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.
| 1. CLEAN PROPELLER SHAFT GREASE |
Place matchmarks on the propeller shaft and sleeve yoke.
 |
Disconnect the sleeve yoke from the propeller shaft.
Clean off any grease on the spline.
| 2. REMOVE FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER ASSEMBLY |
Place matchmarks on the flange yoke and sleeve yoke or propeller shaft.
 |
Using a brass bar and hammer, slightly tap in the spider bearing outer races.
 |
Using 2 screwdrivers, remove the 4 snap rings from the grooves.
Using SST, push out the bearing from the flange.
- SST
- 09332-25010
- HINT:
- Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.
 |
Clamp the bearing outer race in a vise and tap off the flange with a hammer.
- HINT:
- Remove the bearing on the opposite side using the same procedure.
 |
Remove the flange yoke from the sleeve yoke (or propeller shaft).
Install the 2 removed bearing outer races to the spider.
 |
Using SST, push out the bearing from the yoke.
- SST
- 09332-25010
Clamp the outer bearing race in a vise and tap off the yoke with a hammer.
- HINT:
- Remove the bearing on the opposite side using the same procedure.