Automatic Transmission System (For 1Vd-Ftv With Dpf) Hydraulic Test

Drivetrain. Land Cruiser. Urj200, 202 Grj200 Vdj200
Ab60F Automatic Transmission Transaxle. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. PERFORM HYDRAULIC TEST

Automatic Transmission System (For 1Vd-Ftv With Dpf) -- Hydraulic Test



PERFORM HYDRAULIC TEST


  1. Measure the line pressure.

    CAUTION:
    The line pressure test should always be carried out in pairs. One technician should observe the conditions of the wheels and wheel chocks outside the vehicle while the other is performing the test.
    NOTICE:
    1. Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature: 50 to 80°C (122 to 176°F).
    2. Be careful to prevent SST hose from interfering with the exhaust pipe.
    3. This check must be conducted after checking and adjusting the engine.
    4. Perform the test with the A/C turned off.
    5. When conducting the stall test, do not continue for more than 5 seconds.
    6. When performing the stall speed test more than once, make sure to wait 15 seconds or more between tests.

    1. Warm up the ATF (Automatic Transmission Fluid).

    2. Turn the ignition switch off.

    3. Lift the vehicle up.



      4. Land Cruiser. Urj200, 202 Grj200 Vdj200.Ab60F Automatic Transmission Transaxle.Automatic Transmission System (For 1Ur-Fe).Automatic Transmission System (For 1Vd-Ftv With Dpf) Hydraulic Test

    4. Remove the test plug on the transmission case center right side and connect SST.

      SST
      09993-19015(09993-00010,09993-00040)

    5. Lower the vehicle.

    6. Fully apply the parking brake and chock the 4 wheels.

    7. Start the engine and check the idling speed.

    8. Keep your left foot pressed firmly on the brake pedal and move the shift lever to D.

    9. Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches the stall speed.

    10. In the same manner, perform the test with the shift lever in R.

      Specified Line Pressure
      Condition
      		D Position
      		R Position
      Stall speed
      		1230 to 1390 kPa
      (12.5 to 14.2 kgf/cm2, 178 to 202 psi)
      		1470 to 1690 kPa
      (15.0 to 17.2 kgf/cm2, 213 to 245 psi)

      Evaluation
      Problem
      		Possible Cause
      Measured values at D and R positions are higher than specified pressure
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      Measured values at D and R positions are lower than specified pressure
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      3. Oil pump defective
      Pressure is low in D position only
      1. D position circuit fluid leak
      2. Clutch No. 1 (C1) defective
      Pressure is low in R position only
      1. R position circuit fluid leak
      2. Clutch No. 3 (C3) defective
      3. Brake No. 4 (B4) defective