Automatic Transmission System (For 1Vd-Ftv) L4 Position Switch Circuit
Drivetrain. Land Cruiser. Urj200, 202 Grj200 Vdj200
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - BODY GROUND)
CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - ECM)
AUTOMATIC TRANSMISSION SYSTEM (for 1VD-FTV) - L4 Position Switch Circuit |
DESCRIPTION
The 4 wheel drive control ECU judges whether the transfer is in the L4 position based on the information from the limit switch inside the transfer shift actuator assembly which is detected by the ECM. The 4 wheel drive control ECU then inputs a signal to the combination meter assembly via CAN communication and turns on the 4LO indicator.
WIRING DIAGRAM
Refer to DTC P2772 (Click here).
INSPECTION PROCEDURE
| 1.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - BODY GROUND) |
Disconnect the 4 wheel drive control ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
A27-16 (L4) - Body ground
| Always
| 10 kΩ or higher
|
| 2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - ECM) |
Disconnect the ECM connector.
Disconnect the 4 wheel drive control ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for LHDTester Connection
| Condition
| Specified Condition
|
A38-19 (L4) - Body ground
| Always
| 10 kΩ or higher
|
for RHDTester Connection
| Condition
| Specified Condition
|
A52-19 (L4) - Body ground
| Always
| 10 kΩ or higher
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
