Dtc P1575 Warning Buzzer Malfunction
DESCRIPTION
INSPECTION PROCEDURE
PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BUZZER)
CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
DTC P1575 Warning Buzzer Malfunction |
DESCRIPTION
DTC Code
| DTC Detection Condition
| Trouble Area
|
P1575
| The vehicle speed is 50 km/h (30 mph) or more with the cruise control main switch on (vehicle-to-vehicle distance control mode) and the approach warning buzzer malfunctions.
| - Vehicle stability control system
- ECM
|
INSPECTION PROCEDURE
- NOTICE:
- This DTC code may be output under the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability control system first.
1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BUZZER) |
Using the intelligent tester, perform the Active Test (Click here).
ABS/VSC/TRACTester Display
| Test Part
| Control Range
| Diagnostic Note
|
Buzzer
| Skid control buzzer sounds
| OFF or ON
| -
|
- OK:
- Skid control buzzer sounds.
| GO TO VEHICLE STABILITY CONTROL SYSTEM (Skid Control Buzzer Circuit) (Click here) |
|
|
2.CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM) |
Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.
Clear the DTCs (Click here).
Perform the following to make sure the DTC detection conditions are met.
- HINT:
- If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of 50 km/h (30 mph) or more.
Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.
Check for DTCs (Click here).
- OK:
- DTC P1575 is not output.
ResultResult
| Proceed to
|
OK
| A
|
NG (for 1UR-FE)
| B
|
NG (for 3UR-FE)
| C
|