Vehicle Exterior. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Lighting (Ext). Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Side Turn Signal Light Assembly (For Outer Rear View Mirror) -- Installation |
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
| 1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH |
Connect the connector.
Install the side turn signal light assembly LH with the 2 screws.
| 2. INSTALL OUTER MIRROR COVER LH |
Attach the 2 claws as shown in the illustration.
Attach the 6 claws to install the outer mirror cover LH.
After installing the outer mirror cover, check that there is no gap between the cover and mirror body.
If there is a gap between the cover and body, noise will occur during driving.
 |
Using a T25 "TORX" socket wrench, install the screws.
- HINT:
- Clean the threads of the screws with non-residue solvent.
- Apply adhesive to the threads of the screws.
- Adhesive:
- Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Text in Illustration *1 Adhesive
 |
Attach the 5 claws.
Install the rubber base with the screw.
Apply new tape as shown in the illustration.
Text in Illustration *1 Tape *a 40 mm (1.58 in.)
 |
| 3. INSTALL OUTER MIRROR LH |
Attach the 2 claws as shown in the illustration.
 |
Attach the 2 clips to install the outer mirror LH.
- NOTICE:
- Do not push in the glass with excessive force. Doing so may break the mirror surface.
 |
| 4. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH |