Vehicle Interior. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Supplemental Restraint Systems. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Spiral Cable -- Installation |
| 1. INSTALL SPIRAL CABLE SUB-ASSEMBLY |
Attach the 3 claws to install the spiral cable sub-assembly.
- NOTICE:
- When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.
Remove the stopper (new spiral cable).
- HINT:
- When installing a new spiral cable make sure to remove the stopper.
Connect the connectors.
- NOTICE:
- When handling the airbag connector, do not damage the airbag wire harness.
| 2. INSTALL UPPER STEERING COLUMN COVER |
Attach the claw to install the upper cover.
| 3. INSTALL LOWER STEERING COLUMN COVER |
Install the lower cover with the 3 screws.
| 4. ADJUST SPIRAL CABLE SUB-ASSEMBLY (REUSE ONLY) |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Rotate the spiral cable sub-assembly with steering sensor counterclockwise slowly by hand until it feels firm.
- NOTICE:
- Do not use the airbag wire harness to turn the spiral cable sub-assembly.
 |
Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to align the marks.
Text in Illustration *a Mark - NOTICE:
- Do not turn the spiral cable with steering sensor by the airbag wire harness.
- HINT:
- The spiral cable with steering sensor can be rotated approximately 2.5 turns to both the left and right from the center position.
 |
| 5. INSTALL LOWER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
Attach the 3 guides, 2 claws and 3 clips to install the lower instrument panel finish panel.
| 6. INSTALL STEERING WHEEL ASSEMBLY |