Can Communication System (W/ Vsc) Precaution

Care must be taken when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazards when driving.

This vehicle is equipped with an SRS (Supplemental Restraint System), which includes components such as the driver airbag and front passenger side airbag. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may lead to a serious accident. Before servicing (including installation/removal, inspection and replacement of parts), be sure to read the precautionary notice for the Supplemental Restraint System (HILUX_TGN26 RM000000KT10E2X.html).

After repairing the bus line with solder, wrap the repaired part with vinyl tape (HILUX_TGN26 RM000004QR6001X.html).

NOTICE:

1. The CANL bus line and CANH bus line must be installed together.
   
2. When installing the CAN bus lines, make sure to twist them.
   
3. CAN bus lines are likely to be influenced by noise if the bus lines are not twisted together.
   
4. Leave approximately 80 mm (3.15 in.) loose in the twisted wires around the connectors.
   

Do not use by-pass wiring between the connectors.

NOTICE:

The protective effect of the twisted wire harness will be lost if bypass wiring is used.

When inserting probes into a connector, insert them from the rear of the connector.

Use a repair wire to check the connector if it is impossible to check resistance from the rear of the connector.