Rear View Monitor System (For Radio And Display Type) Precaution

Audio Visual Telematics. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Park Assist Monitoring. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25

  1. POINTS TO NOTE WHEN SERVICING

  1. NOTES FOR REAR TELEVISION CAMERA ASSEMBLY

Rear View Monitor System (For Radio And Display Type) -- Precaution



1.POINTS TO NOTE WHEN SERVICING

  1. Pay attention to the following point when servicing.

    1. When the lens of the rear television camera assembly is dirty, wash the lens with water and wipe it off with a soft cloth to obtain clear images. For heavy dirt, use neutral detergent to clean the lens.


2.NOTES FOR REAR TELEVISION CAMERA ASSEMBLY

  1. Notes for the rear television camera assembly

    1. The rear view monitor system may not function properly if the rear television camera assembly is subjected to a severe blow by any hard object.

    2. Do not scrub the cover part of the camera (resin made). Scrubbing may scratch the cover and affect the image. Prevent organic solvents, waxes, bond removing solvents or glass coating from adhering to the cover. If such material adheres to the cover, clean it off immediately and wash with water.

    3. Exposing the camera to a sudden temperature change may affect proper functioning of the camera.

    4. A clear image may not appear if the camera is dirty with snow, mud, etc. In that case, wash it with water and wipe off the lens. Use a detergent to remove dirt if necessary.

  2. Images are difficult to discern even in normal conditions if:

    1. Noise may occur in the image depending on electrical devices used in the cabin.

    2. Noise may occur in the image if accessories that generate radio waves have been installed.

    3. The camera screen is frosted over (the image immediately after turning the ignition switch to ON may be blurred or darker than normal).

    4. The camera lens is dirty with snow, mud, etc.

    5. A strong beam of light, such as a sunbeam or headlight, hits the camera.

    6. It is too dark around the camera (at night, etc.).

    7. The ambient temperature around the camera is either too high or too low.

    8. The vehicle is tilted at a steep angle.

    9. The ambience of the camera is too bright. (When a strong light, such as a sunbeam reflected off the vehicle body, hits the camera, the image may be blurred. This is called the "SMEAR" phenomenon, particular to the CCD camera.)