Audio And Visual System - Radio Receiver Power Source Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT RADIO RECEIVER
AUDIO AND VISUAL SYSTEM - Radio Receiver Power Source Circuit
DESCRIPTION
This circuit provides power to the radio receiver.
WIRING DIAGRAM

INSPECTION PROCEDURE
Disconnect the radio receiver connector J66.
Measure the resistance according to the value in the table below.
- Standard resistance:
Tester connection | Condition | Specified condition |
GND - Body ground | Always | Below 1 Ω |
Measure the voltage according to the values in the table below.
- Standard voltage:
Tester connection | Condition | Specified condition |
B - GND | Always | 10 to 14 V |
ACC - GND | Engine switch on (ACC) | 10 to 14 V |
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
OK | |
| |
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|