Audio And Visual System - Avc-Lan Circuit
DESCRIPTION
INSPECTION PROCEDURE
INSPECT RADIO RECEIVER
CHECK HARNESS AND CONNECTOR
AUDIO AND VISUAL SYSTEM - AVC-LAN Circuit
DESCRIPTION
Each unit of the audio system connected to the AVC-LAN (communication bus) transfers the signal of each switch by communication.
When a short to +B or short to ground occurs in this AVC-LAN, the audio system will not function normally as the communication is discontinued.
INSPECTION PROCEDURE
Disconnect the radio receiver connectors.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection | Condition | Specified Condition |
ATX+ - ATX- | Always | 60 to 80 Ω |
TXM+ - TXM- | Always | 60 to 80 Ω |
TX+ - TX- | Always | 60 to 80 Ω |
2.CHECK HARNESS AND CONNECTOR |
- For details of the connectors, refer to the "TERMINALS OF ECU" .
Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.
Disconnect all connectors in all AVC-LAN circuits.
Check for an open or short in all AVC-LAN circuits.
- OK:
- There is no open or short circuit.

| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
OK | |
| |
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|