Brake Pedal (W/ Vsc) Installation

Brake. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Brake System (Other). Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25

  1. INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY

  2. CONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS

  3. CHECK AND ADJUST BRAKE PEDAL HEIGHT

  4. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Brake Pedal (W/ Vsc) -- Installation



1. INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY

  1. Install the support with the 4 nuts.

    Torque:
    14 N*m{145 kgf*cm, 10 ft.*lbf}

  1. for Manual Transmission:
    Attach the connector clamp and clamp to the brake pedal support sub-assembly.

  1. Install the bolt to the support.

    Torque:
    18 N*m{184 kgf*cm, 13 ft.*lbf}


2. CONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS

  1. Apply a light coat of lithium soap base glycol grease to the clevis pin.

  1. Connect the push rod clevis to the brake pedal.



    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25.Brake System (Other).Brake System.Brake Pedal (W/ Vsc) Installation

  1. Install the clevis pin and a new clip.

    Text in Illustration
    *1
    		Brake Pedal Return Spring
    *2
    		Clevis Pin
    *3
    		Clip
    NOTICE:
    The clip must be installed as shown in the illustration.

  1. Install the return spring.

  1. Connect the stop light switch connector and brake pedal load sensing switch connector.



3. CHECK AND ADJUST BRAKE PEDAL HEIGHT
(HILUX_TGN26 RM0000010K5010X.html)


4. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
(HILUX_TGN26 RM000003O2K00PX.html)


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (HILUX_TGN26 RM000004QR300CX.html).