Brake. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Brake Control Dynamic Control Systems. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Front Speed Sensor (For 4Wd And Pre-Runner) -- Removal |
- HINT:
- The procedure listed below is for the LH side.
- Other than areas where instructions are provided, use the same procedure for the LH and RH sides.
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (HILUX_TGN26 RM000004QR1003X.html).
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (HILUX_TGN26 RM000004QR3003X.html).
| 3. REMOVE FRONT WHEEL |
| 4. REMOVE FRONT SPEED SENSOR LH |
Disconnect the connector.
Text in Illustration *A for LH *B for RH
Detach the 2 clamps and the connector.
Detach the 2 clamps.
 |
Detach the clamp.
 |
Remove the 2 bolts and 2 harness clamps.
Detach the 2 clamps.
Text in Illustration *A w/ VSC *B w/o VSC
Remove the bolt and harness clamp.
Remove the bolt and speed sensor.
- NOTICE:
- Keep the sensor tip and sensor installation hole free from foreign matter.
| 5. REMOVE SKID CONTROL SENSOR CLAMP |
Remove the bolt and skid control sensor clamp from the knuckle.
Text in Illustration *A for LH *B for RH