Engine Hybrid System. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
2Tr-Fe Engine Control. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
TYPICAL MALFUNCTION THRESHOLDS
DTC P060E Internal Control Module Throttle Position Performance |
DESCRIPTION
The ECM monitors the input signals of the throttle position sensor No. 1 and stop light switch. If the input signals and control signals deviate, a DTC is stored.| DTC No. | DTC Detection Condition | Trouble Area |
| P060E | Either condition is met (1 trip detection logic):
| ECM |
MONITOR STRATEGY
| Required sensors/Components | ECM |
| Frequency of operation | Once per driving cycle |
TYPICAL ENABLING CONDITIONS
| DMA communication error | Not detected |
TYPICAL MALFUNCTION THRESHOLDS
| When one of following conditions is met: | Condition 1 or 2 |
| 1. Difference of main throttle position and sub throttle position | 0.3 V or more |
| 2. Stop light switch signal (CPU) and stop light switch signal (Monitor IC) | Different |
CONFIRMATION DRIVING PATTERN
- Turn the ignition switch off.
- Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
- Connect the cable to the negative (-) battery terminal.
- Turn the ignition switch to ON and wait for 16 seconds or more.
INSPECTION PROCEDURE
| 1.CHECK FOR DTC |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Clear the DTCs (HILUX_TGN26 RM000000PDK0SXX.html).
Turn the intelligent tester off.
Turn the ignition switch off.
Disconnect the intelligent tester.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Check for DTCs.
- OK:
- P060E is not output.
|
| ||||
| OK | ||
| ||