Headlight Dimmer Switch (For Sedan) Installation

Vehicle Exterior. Yaris. Ncp93, 131
Lighting (Ext). Yaris. Ncp93, 131

  1. INSTALL HEADLIGHT DIMMER SWITCH

  2. INSTALL WIPER SWITCH

  3. INSTALL SPIRAL CABLE

  4. INSTALL STEERING COLUMN COVER

  5. ADJUST SPIRAL CABLE

  6. INSTALL STEERING WHEEL ASSEMBLY

  7. INSTALL STEERING PAD

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  9. INSPECT SRS WARNING LIGHT

Headlight Dimmer Switch (For Sedan) -- Installation



1. INSTALL HEADLIGHT DIMMER SWITCH


    Yaris. Ncp93, 131
  1. Engage the 2 claws and install the headlight dimmer switch, as shown in the illustration.



    Yaris. Ncp93, 131
  1. Install the headlight dimmer switch with the clamp.

  1. Connect the connector.



2. INSTALL WIPER SWITCH


Yaris. Ncp93, 131
  1. Engage the claw and install the windshield wiper switch.

  1. Connect the 2 connectors.



3. INSTALL SPIRAL CABLE


Yaris. Ncp93, 131
  1. Check that the ignition switch is turned to OFF.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    Do not begin the operation for at least 90 seconds after the negative battery terminal is detached.
  1. Confirm that the front tires face straight forward.

  1. Confirm that the turn signal switch is in the neutral position.

    NOTICE:
    Perform the operation when the turn signal switch is in the neutral position. Otherwise, the pin of the turn signal will break.
  1. Engage the 3 claws and install the spiral cable.

    NOTICE:
    Pull the lock pin out before installing the steering wheel, when replacing the spiral cable with a new one.


    Yaris. Ncp93, 131.Lighting (Ext).Lighting System (For Sedan).Headlight Dimmer Switch (For Sedan)  Installation
  1. Connect the airbag connector.

  1. Connect the horn connector.



4. INSTALL STEERING COLUMN COVER


Yaris. Ncp93, 131
  1. Engage the 2 claws and install the steering column cover (upper).

  1. Engage the 2 claws and install the steering column cover (lower).

  1. Tighten the 3 screws.



5. ADJUST SPIRAL CABLE


    Yaris. Ncp93, 131
  1. Center the spiral cable.

    1. Turn the spiral cable counterclockwise until it locks.

      HINT:
      The spiral cable turns a maximum of approximately 5 times.


    2. Yaris. Ncp93, 131.Lighting (Ext).Lighting System (For Sedan).Headlight Dimmer Switch (For Sedan)  Installation
    3. Turn the spiral cable 2.5 times clockwise from its locked position and align the center marks.



6. INSTALL STEERING WHEEL ASSEMBLY


    Yaris. Ncp93, 131.Lighting (Ext).Lighting System (For Sedan).Headlight Dimmer Switch (For Sedan)  Installation
  1. Align the matchmarks and install the steering wheel assembly onto the steering column assembly.

  1. Install the nut.

    Torque:
    50 N*m{510 kgf*cm, 37 ft.*lbf}
  1. Connect all connectors to the spiral cable.



7. INSTALL STEERING PAD


Yaris. Ncp93, 131.Lighting (Ext).Lighting System (For Sedan).Headlight Dimmer Switch (For Sedan)  Installation
NOTICE:
Do not use a steering pad that has been dropped.
  1. Confirm that the ignition switch is turned to OFF.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    Do not begin the operation for at least 90 seconds after the negative battery terminal is detached.
  1. Connect the horn terminal.

  1. Connect the airbag connector.

    NOTICE:
    1. Match the color of the airbag connector with that of the steering pad assembly, and install the airbag connector.
    2. Securely lock the locking button.


    Yaris. Ncp93, 131
  1. Install the steering pad.

  1. Using "Torx" socked wrench T30, tighten the 2 bolts.

    Torque:
    8.8 N*m{90 kgf*cm, 78 in.*lbf}
    NOTICE:
    Tighten the 2 bolts while holding the steering pad to prevent it moving upward.


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque:
5.4 N*m{55 kgf*cm, 48 in.*lbf}


9. INSPECT SRS WARNING LIGHT
(YARIS_NCP93 RM000000XFD0CVX.html).