Front Wiper Motor (For Sedan) Installation

Install the front wiper motor with the 3 bolts.

Torque:

5.4 N*m{55 kgf*cm, 48 in.*lbf}

Apply DENSO No. 50 grease to the crank arm pivot of the front wiper motor.

Install the rod onto the crank arm pivot of the front wiper motor.

Connect the connector.

Slide the wiper link as shown in the illustration and engage the rubber pin with the body.

Install the front wiper motor and link with the 2 bolts.

Torque:

5.5 N*m{56 kgf*cm, 49 in.*lbf}

Connect the washer hoses.

Engage the 5 hooks.

Engage the 8 hooks and the 4 claws.

Install the cowl top ventilator louver sub-assembly with the 3 clips.

Engage the 3 claws and install the cowl side ventilator sub-assembly LH.

Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).

Clean the wiper pivot serrations with a wire brush.

Operate the wiper, then stop the windshield wiper motor in the automatic stop position.

Align the blade tip with the mark on the windshield glass, as shown in the illustration.

Tighten the nut of the front wiper arm.

Torque:

26 N*m{265 kgf*cm, 19 ft.*lbf}

Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).

Clean the wiper pivot serrations with a wire brush.

Operate the wiper, then stop the windshield wiper motor in the automatic stop position.

Align the blade tip with the mark on the windshield glass, as shown in the illustration.

Tighten the nut of the front wiper arm.

Torque:

26 N*m{265 kgf*cm, 19 ft.*lbf}

Engage the claw and install the 2 front wiper arm head caps.