Power Window Regulator Motor (For Sedan Rear Side) Installation

Apply MP grease to the sliding and rotating areas of the regulator motor.

Using "TORX" socket wrench T25, install the power window regulator motor with the 3 screws.

Torque:

5.4 N*m{55 kgf*cm, 48 in.*lbf}

w/ Power window:

1. Apply MP grease to the sliding and rotating areas of the rear door window regulator.
   

   NOTICE:

   Do not apply grease to the window regulator spring.





2. Loosely screw bolt A onto the rear door window regulator.
   

3. Insert the rear door window regulator into the door panel. Use bolt A to hang the rear door window regulator on the door panel.
   

   NOTICE:

   Do not drop the window regulator as it may be damaged.

4. Install the rear door window regulator with the 4 bolts, and tighten bolt A.
   

   Torque:

   8.0 N*m{82 kgf*cm, 71 in.*lbf}

5. Connect the connector.
   

w/o Power window:

1. Apply MP grease to the sliding and rotating areas of the rear door window regulator.
   

   NOTICE:

   Do not apply grease to the window regulator spring.





2. Install the rear door window regulator with the 3 bolts.
   

   Torque:

   8.0 N*m{82 kgf*cm, 71 in.*lbf}

w/ Power window:

1. Install the rear door glass onto the rear door window regulator.
   

w/o Power window:

1. Install the rear door glass onto the rear door window regulator.
   

Install the rear door window division bar with the 2 bolts and screw.

Torque:

6.2 N*m{63 kgf*cm, 54 in.*lbf}

Install the rear door glass run.

Engage the 5 claws and install a new rear door belt moulding.

Remove the protective tape.

Engage the 32 clips and install the rear door weatherstrip.

Apply MP grease to the sliding areas of the door check.

Install the rear door check onto the door panel with the 2 bolts.

Torque:

5.5 N*m{56 kgf*cm, 49 in.*lbf}

Apply adhesive to the threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or the equivalent.

Install the rear door check onto the body panel with the bolt.

Torque:

30 N*m{306 kgf*cm, 22 ft.*lbf}

Apply butyl tape to the door panel, then install the rear door service hole cover as shown in the illustration.

Specification:

Area	Dimension
A	2.0 mm (0.079 in.) or more
B	6.0 mm (0.236 in.) or more

HINT:

1. When installing the service hole cover, pull the links and connectors out through the service hole.
   
2. There should be no wrinkles or folds after attaching the service hole cover.
   
3. After attaching the service hole cover, check the quality of the seal.
   

Install the rear door trim bracket with the 2 screws.

Connect the rear door lock remote control cable and rear door inside locking cable.

Engage the 7 clips and install the rear door trim board.

Tighten the screw.

Engage the 4 claws and install the rear door armrest base upper panel.

Install the screw.