Front Seat Assembly (For Sedan) -- Removal |
- CAUTION:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (YARIS_NCP93 RM000000KT10D1X.html).
- NOTICE:
- Always use "TORX" socket wrench E10 when removing the front seat.
- HINT:
- The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
| 2. REMOVE FRONT SEAT HEADREST ASSEMBLY |
Push in the lock button of the front seat headrest support and remove the front seat headrest.
 |
| 3. REMOVE FRONT SEAT ASSEMBLY (for LH Side) |
w/Front passenger airbag:
Using a clip remover, remove the clamp.
Slide the slider and disconnect the airbag connector.
Disconnect the buckle switch connector.
 |
w/o Front passenger airbag:
Disconnect the buckle switch connector.
Move the front seat to its most rearward position.
 |
Using "TORX" socket wrench E10, remove the 2 bolts from the front side.
Move the front seat to its most forward position.
Using "TORX" socket wrench E10, remove the 2 bolts from the rear side.
Remove the front seat.
| 4. REMOVE FRONT SEAT ASSEMBLY (for RH Side) |
w/Front passenger airbag:
Using a clip remover, remove the clamp.
Slide the slider and disconnect the airbag connector.
Disconnect the buckle switch connector.
Disconnect the occupant detection ECU connector.
 |
w/o Front passenger airbag:
Disconnect the buckle switch connector.
Move the front seat to its most rearward position.
 |
Using "TORX" socket wrench E10, remove the 2 bolts from the front side.
Move the front seat to its most forward position.
Using "TORX" socket wrench E10, remove the 2 bolts from the rear side.
Remove the front seat.