Side Airbag Sensor (For Hatchback Front Side) Installation

Check that the ignition switch is off.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Engage the guide and install the airbag sensor with the bolt.

Torque:

9.0 N*m{92 kgf*cm, 80 in.*lbf}

NOTICE:

1. If the door side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
   
2. When installing the door side airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
   
3. Make sure that the pin (stopper) is securely inserted into the body hole.
   
4. Tighten the bolt while holding the door side airbag sensor because the door side airbag sensor pin (stopper) is easily damaged.
   

Connect the connector to the door side airbag sensor.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.

1. Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original position and a click sound can be heard).
   
   

   
   
   
   
   

   Text in Illustration

   *1	Outer Connector Locking Sleeve	-	-
   *a	Slide	-	-

   HINT:

   When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting, as it may result in an insecure fit.

Check that there is no looseness in the installation parts of the door side airbag sensor.

Connect the front door lock remote control cable and the front door inside locking cable to the front door inside handle.

Engage the 7 clips and the front door trim board.

Install the 3 screws.

Engage the claw and close the cover.

Connect the front door lock remote control cable and the front door inside locking cable to the front door inside handle.

Engage the 8 clips and the front door trim board.

Install the 3 screws.

Engage the claw and close the cover.

Connect the connector.

Engage the 9 claws and 4 guides, and install the front armrest base upper panel.

Connect the connector.

HINT:

If the armrest base upper panel is equipped with door lock switch, connect the connector.

Engage the 6 claws and 3 guides, and install the front armrest base upper panel.

Install the window regulator handle plate.

Open all the windows.

Install the front door window regulator handle with clip at the angle shown in the illustration.