Front Airbag Sensor (For Sedan) -- Installation |
- CAUTION:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (YARIS_NCP93 RM000000KT10D1X.html).
- HINT:
- The procedure described below is for the LH side. Use the same procedure for both the LH and RH sides, unless otherwise specified.
| 1. INSTALL FRONT AIRBAG SENSOR |
 |
- NOTICE:
- Do not use a front airbag sensor that has been dropped.
- Do not subject the front airbag sensor any impact or force.
Confirm that the ignition switch is turned to off.
Confirm that the negative battery terminal is detached.
- CAUTION:
- Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
- Do not start the operation for at least 90 seconds after disconnecting the negative battery terminal.
Connect the airbag connector.
Check that the CPA is in the provisionally locked condition.
Push the CPA until it makes a click sound.
- NOTICE:
- Engage the connector by pushing it straight.
- Hold the CPA when engaging the connector.
- Do not engage the CPA while pressing the CPA upper portion, otherwise, the half connection prevention mechanism will not function.
Confirm that the rear side of the housing and the CPA rear surface are tightly fitted together.
Install the front airbag sensor with the 2 bolts.
- Torque:
- 9.0 N*m{90 kgf*cm, 80 in.*lbf}
 |
Confirm that there is no looseness by shaking the front airbag sensor.
| 2. INSTALL FRONT BUMPER COVER (w/ Large Front Spoiler) |
Install the 2 clips, screw grommet and the 6 spring nuts.
 |
Engage the 6 claws and install the front bumper cover.
 |
Connect the connectors.
- HINT:
- If the vehicle is equipped with fog lights, connect the connector.
Install the 6 clips.
 |
Install the 2 screw grommets.
Tighten the 9 bolts and the 7 screws.
Remove the protective tape.
 |
| 3. INSTALL FRONT BUMPER COVER (w/ Small Front Spoiler) |
Install the 2 clips, the screw grommet and the 10 spring nuts.
 |
Engage the 6 claws and install the front bumper cover.
|
Connect the connectors.
- HINT:
- If the vehicle is equipped with fog lights, connect the connectors.
Install the 6 clips.
 |
Install the 2 screw grommets.
Tighten the 5 screws and the 3 bolts.
Remove the protective tape.
|
| 4. INSTALL FRONT BUMPER COVER (w/o Front Spoiler) |
Install the 2 clips and the screw grommet.
 |
Engage the 6 claws and install the front bumper cover.
|
Connect the connectors.
- HINT:
- If the vehicle is equipped with fog lights, connect the connectors.
Install the 6 clips.
 |
Install the 2 screw grommets.
Tighten the 7 screws and the 3 bolts.
Remove the protective tape.
|
| 5. INSTALL FRONT SPOILER COVER (w/ Front Spoiler) |
Install the front spoiler cover with the 2 screws and the 10 bolts.
 |
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{55 kgf*cm, 48 in.*lbf}
| 7. INSPECT SRS WARNING LIGHT |