Meter / Gauge System (For Sedan) Driver Side Seat Belt Warning Light Does Not Operate
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK SUPPLEMENTAL RESTRAINT SYSTEM
PERFORM ACTIVE TEST USING TECHSTREAM (D-BELT REMIND)
METER / GAUGE SYSTEM (for Sedan) - Driver Side Seat Belt Warning Light does not Operate |
DESCRIPTION
- When the ignition switch is ON, the center airbag sensor assembly communicates the status of the front seat inner belt assembly LH to the main body ECU using the CAN communication line. The main body ECU receives signals from the center airbag sensor assembly and transmits them to the combination meter assembly. When the seat belt is unfastened, the combination meter assembly flashes the driver seat belt warning light in the combination meter assembly. When the seat belt is fastened, the combination meter assembly stops flashing the front driver seat belt warning light.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.CHECK SUPPLEMENTAL RESTRAINT SYSTEM |
Connect the Techstream to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes.
- Result:
Result
| Proceed to
|
No SRS DTCs are output
| A
|
SRS DTCs are output
| B
|
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (D-BELT REMIND) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Body Electrical / Combination Meter / Active Test::
Tester Display
| Test Part
| Control Range
| Diagnostic Note
|
Driver Side Seat Belt
| Driver side seat belt warning light
| OFF/ON
| Vehicle is stopped and engine is idling
|
- OK:
- Front driver seat belt warning light comes on.
