Meter / Gauge System (For Sedan) Tachometer Malfunction
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
PERFORM ACTIVE TEST USING TECHSTREAM (TACHOMETER)
READ VALUE USING TECHSTREAM (TACHOMETER)
METER / GAUGE SYSTEM (for Sedan) - Tachometer Malfunction |
DESCRIPTION
The combination meter assembly controls the tachometer in accordance with engine speed signals from the ECM through the CAN communication system.
WIRING DIAGRAM
INSPECTION PROCEDURE
- HINT:
- If DTC U0100 has been stored, troubleshoot the CAN communication system first.
| 1.PERFORM ACTIVE TEST USING TECHSTREAM (TACHOMETER) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Body Electrical / Combination Meter /Active Test.
- Body Electrical / Combination Meter / Active Test::
Tester Display
| Test Part
| Control Range
| Diagnostic Note
|
Tachometer Operation
| Tachometer
| 0/1000/2000/3000/4000/5000/6000/7000 rpm
| -
|
- OK:
- Engine speed displayed on the tester is approximately the same as that of the tachometer reading.
| 2.READ VALUE USING TECHSTREAM (TACHOMETER) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Select the item below from the Data List, and read the value displayed on the Techstream.
- Body Electrical / Combination Meter / Data List::
Tester Display
| Measurement Item/Range
| Normal Condition
| Diagnostic Note
|
Engine Rpm
| Engine speed/Min.: 0 rpm, Max.: 12,750 rpm
| Approximately same as actual engine speed (When engine is running)
| -
|
- OK:
- Engine speed displayed on the tester is approximately the same as the actual engine speed.
