Theft Deterrent System (For Sedan) Data List / Active Test

Vehicle Interior. Yaris. Ncp93, 131
Theft Deterrent Keyless Entry. Yaris. Ncp93, 131

  1. DATA LIST

  1. ACTIVE TEST

Theft Deterrent System (For Sedan) -- Data List / Active Test



DATA LIST
HINT:
Using Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Warm up the engine.

  2. Turn the ignition switch to OFF.

  3. Connect the Techstream to the DLC3.

  4. Turn the ignition switch to ON.

  5. Turn the tester ON.

  6. Enter the following menus: Body Electrical / Main Body / Data List /

  7. According to the display on tester, read the "Data List".

    Theft Warning ECU:
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    Luggage door lock/unlock switch
    		Luggage compartment door unlock detection switch signal/ON or OFF
    		ON: Luggage compartment door is unlocked
    OFF: Luggage compartment door is locked
    		-
    Hood Courtesy Switch
    		Engine hood courtesy switch signal/ON or OFF
    		ON: Engine hood is open
    OFF: Engine hood is closed
    		-
    IG SW
    		Ignition switch signal/ON or OFF
    		ON: Key is in ON or START position
    OFF: Key is in LOCK or ACC position
    		-
    Key Unlock Warning Switch
    		Unlock warning switch signal/ON or OFF
    		ON: Key is inserted into ignition key cylinder
    OFF: Key is removed from ignition key cylinder
    		-
    Alarm Trigger
    		Alarm Trigger
    		D CRTSY: Alarms are caused by door courtesy light switch
    D POS: Alarms are caused by door position switch
    H CRTSY: Alarms are caused by hood courtesy switch
    L CRTSY: Alarms are caused by luggage compartment door courtesy switch
    IG SW: Alarms are caused by ignition switch
    OPEN: Alarms are caused by open circuit
    NO SIG: No signals
    		-
    Passive mode (Security system)
    		Passive mode/ON or OFF
    		ON: When switched from active mode
    OFF: When switched to active mode
    		-
    Warning by Horn
    		Warning by horn/ON or OFF
    		ON: When switched from armed state to alarm sounding state
    OFF: When switched from alarm sounding state to armed state or disarmed state
    		-
    Entry Delay Time
    		Entry delay time during passive mode
    		0s: Entry delay time is 0 sec.
    14s: Entry delay time is 14 sec.
    30s: Entry delay time is 30 sec.
    		-

    Main Body ECU:
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    D Door Courtesy SW
    		Driver side door courtesy switch signal / ON or OFF
    		ON: Driver side door is open
    OFF: Driver side door is closed
    		-
    D-Door Lock Pos SW
    		Driver side door unlock detection switch signal / ON or OFF
    		ON: Driver side door is unlocked
    OFF: Driver side door is locked
    		-
    P Door Courtesy SW
    		Passenger side door courtesy switch signal / ON or OFF
    		ON: Passenger side door is open
    OFF: Passenger side door is closed
    		-
    P-Door Lock Pos SW
    		Passenger side door unlock detection switch signal / ON or OFF
    		ON: Passenger side door is unlocked
    OFF: Passenger side door is locked
    		-
    Luggage Courtesy SW
    		Luggage compartment door courtesy switch/ON or OFF
    		ON: Luggage compartment door is open
    OFF: Luggage compartment door is closed

    ACC SW
    		ACC switch signal/ON or OFF
    		ON: Key is in ACC position
    OFF: Key is in LOCK position
    		-


ACTIVE TEST
HINT:
Using Techstream to perform Active Test allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. The Data List can be displayed while performing Active Tests.

  1. Warm up the engine.

  2. Turn the ignition switch to OFF.

  3. Connect the Techstream to the DLC3.

  4. Turn the ignition switch to ON.

  5. Turn the tester ON.

  6. Enter the following menus: Body Electrical / Main Body / Active Test /

  7. According to the display on tester, read the "Active Test".

    Theft Warning ECU:
    Tester Display
    		Test Part
    		Control Range
    		Diagnostic Note
    Security Indicator
    		Security indicator
    		ON/OFF
    		-
    Security Horn
    		Security horn
    		ON/OFF
    		-

    Main Body ECU:
    Tester Display
    		Test Part
    		Control Range
    		Diagnostic Note
    Hazard
    		Hazard warning light
    		ON/OFF
    		-
    Vehicle Horn
    		Vehicle horn
    		ON/OFF
    		-
    Taillight Relay
    		Taillight relay
    		ON/OFF
    		-
    Headlight Relay
    		Headlight relay
    		ON/OFF
    		-