Parking Brake Cable (For Hatchback Drum Type) Removal

Loosen the equalizer and lock nut.

NOTICE:

Do not reuse the loosened nut.

Release the parking brake and remove the rear brake drum.
If the rear brake drum cannot be removed easily, perform the following procedure.

Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.

Text in Illustration

*1	Automatic Adjust Lever
	Contract

Using another screwdriver, contract the brake shoe by turning the adjusting bolt.

Using SST, separate the shoe return spring from the front brake shoe.

SST

09921-00011

NOTICE:

Do not damage the wheel cylinder boot.

Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and front brake shoe.

SST

09718-00011

Remove the tension spring.

Remove the shoe return spring from the rear brake shoe and remove the parking brake shoe strut set.

Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.

SST

09718-00011

Using needle-nose pliers, separate the parking brake cable.

Remove the 2 nuts and the front No. 4 floor heat insulator.

Pinch and remove the clip as shown in the illustration.

Remove the bolt and the fuel tank cover vent case sub-assembly.

Separate the No. 3 parking brake cable assembly from the parking brake equalizer.

Remove cable clamp A from the body.

Remove the 5 bolts.

Remove cable clamp B from the rear axle beam.

Remove the bolt and No. 3 parking brake cable assembly from the backing plate.