Rear Speed Sensor (For Sedan) Installation

Install the axle hub and bearing onto the axle beam with the 4 bolts.

Torque:

90 N*m{918 kgf*cm, 67 ft.*lbf}

Inspect the axle hub and bearing backlash.

1. Using a dial indicator, check the backlash near the center of the axle hub.
   

   Maximum:

   0.05 mm (0.0020 in.)
   

   If the backlash exceeds the maximum, replace the axle hub and bearing.
   

Inspect the axle hub and bearing runout.

1. Using a dial indicator, check the runout of the surface of the axle hub.
   

   Maximum:

   0.07 mm (0.0028 in.)
   

   If the runout exceeds the maximum, replace the axle hub and bearing.
   

Connect the skid control sensor wire connector.

Provisionally install the 2 hub nuts.

Remove the hole plug, and turn the adjuster to expand the shoe until the drum locks.

Using a screwdriver, release the adjuster 12 notches.

Install the hole plug.