Cruise Control System (For Hatchback) Clutch Switch Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT NO. 2 CLUTCH START SWITCH ASSEMBLY
CHECK HARNESS AND CONNECTOR (NO. 2 CLUTCH START SWITCH ASSEMBLY - ECM AND BATTERY)
CRUISE CONTROL SYSTEM (for Hatchback) - Clutch Switch Circuit |
DESCRIPTION
While depressing the clutch pedal, the clutch switch sends a signal to terminal 81 (D) of the ECM. The ECM cancels cruise control when terminal 81 (D) receives the signal.
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1.INSPECT NO. 2 CLUTCH START SWITCH ASSEMBLY |
Inspect the No. 2 clutch start switch assembly (YARIS_NCP93 RM000001Z6F02FX.html).
| 2.CHECK HARNESS AND CONNECTOR (NO. 2 CLUTCH START SWITCH ASSEMBLY - ECM AND BATTERY) |
Disconnect the A67 No. 2 clutch start switch assembly connector.
Disconnect the C51 ECM connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
| Switch Condition
| Specified Condition
|
A67-1 - Body ground
| Ignition switch ON
| 11 to 14 V
|
Ignition switch off
| Below 1 V
|
Text in Illustration*a
| Front view of wire harness connector
(to No. 2 Clutch Start Switch Assembly)
|
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
A67-2 - C51-81 (D)
| Always
| Below 1 Ω
|
A67-2 - Body ground
| Always
| 10 kΩ or higher
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
