Heated Oxygen Sensor (For Sedan) Installation

Using SST, install the heated oxygen sensor onto the front exhaust pipe.

SST

09224-00010

Torque:

without SST:

44 N*m{449 kgf*cm, 32 ft.*lbf}

with SST:

40 N*m{408 kgf*cm, 30 ft.*lbf}

HINT:

1. This torque value is effective when SST is parallel to the torque wrench.
   
2. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
   
3. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).
   
4. If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values (YARIS_NCP93 RM000000UYX0BYX.html).
   

Pass the sensor connector through the floor panel and install the grommet.

Connect the sensor connector.

Engage the claw and 3 clips and install the instrument pad lower.

Install screw <I>.

Engage the 4 claws and install the rear console box.

Install the 2 bolts and 2 screws.

Connect the clamp.

Install the console box carpet.

Connect the connector.

Engage the 3 clips and 3 claws and install the console upper rear panel.

Engage the 5 clips and the claw and install the upper console panel.

Engage the 6 claws and 3 clips and install the instrument panel finish panel end LH.

Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.