Rear Door Belt Moulding Installation

Engage the 6 claws and 2 clips, and install the rear door belt moulding assembly.

Install the rear door glass run.

Slide the rear door glass sub-assembly to install it as shown in the illustration.

Install the rear door quarter window glass to the rear door quarter window weatherstrip.

Install the rear door quarter window glass together with the rear door quarter window weatherstrip in the direction indicated by the arrow in the illustration.

Insert the rear door window division bar sub-assembly from above.

Install the rear door glass run to the rear door window division bar sub-assembly.

Install the rear door window division bar sub-assembly with the 2 bolts and screw.

Torque:

6.2 N*m{63 kgf*cm, 55 in.*lbf}

Apply butyl tape to the rear door panel.

Pass the rear door lock remote control cable, rear door inside locking cable and each connector through a new rear door service hole cover.

Attach the rear door service hole cover according to the reference points on the rear door panel.

NOTICE:

Securely install the rear door service hole cover preventing wrinkles and air bubbles.

w/ Power door lock:

1. Connect the connector.
   

Install the rear door trim bracket with the 2 screws.

Install the rear door inner glass weatherstrip.

Connect the rear door lock remote control cable and rear door inside locking cable to the rear door inside handle.

Engage the 2 claws and install the rear door inside handle sub-assembly to the rear door trim board.

Engage the rear door trim board with the 4 claws on the rear door inner glass weatherstrip.

Engage the 8 clips to install the rear door trim board to the rear door panel.

Install the 2 screws.

Engage the claw to install the door armrest cap.

Engage the 2 clips and 7 claws, and install the rear door armrest upper base panel.

Connect the connector.

Engage the 2 clips and 7 claws, and install the rear door armrest upper base panel.

Engage the 3 claws and install the rear door inside handle bezel.

Temporarily install the rear door window regulator handle assembly and fully close the window glass.

Install the rear door regulator inside handle plate.

Install the snap ring to the rear door window regulator handle assembly.

Install the rear door window regulator handle assembly as shown in the illustration.