Hazard Warning Switch Removal

Disengage the 3 claws and clip, and then remove the lower instrument panel finish panel LH.

Disengage the 3 claws and clip, and then remove the lower instrument panel finish panel RH.

Apply protective tape to the area shown in the illustration.

Insert a roof moulding remover and slide it toward the clip.

Pull the remover with both hands to disengage the clip as shown in the illustration.

Disengage the 2 claws and clip, and remove the instrument panel finish panel end LH.

Apply protective tape to the area shown in the illustration.

Insert a roof moulding remover and slide it toward the clip.

Pull the remover with both hands to disengage the clip as shown in the illustration.

Disengage the 2 claws and clip, and remove the instrument panel finish panel end RH.

Disengage the 2 claws, 4 clips, and 2 guides.

w/o Daytime Running Light:

1. Disengage the clamp.
   

Disconnect each connector and remove the center instrument panel register assembly.

Disengage the 2 claws and remove the hazard warning signal switch assembly.