Wiper Switch Installation

Engage the claw and install the windshield wiper switch assembly as shown in the illustration.

Connect the 2 connectors.

Engage the claw and the 2 pins, and install the upper steering column cover.

Engage the 2 claws to install the lower steering column cover.

Engage the 4 claws.

Engage the claw.

HINT:

Press the area around the claw to engage it.

Engage the 5 claws, 2 clips and 2 guides.

Install the lower instrument panel finish panel sub-assembly with the 2 screws <B>.

Check that the ignition switch is off.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Rotate the spiral cable counterclockwise slowly by hand until it stops.

NOTICE:

Do not turn the spiral cable using the airbag wire harness.

Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

NOTICE:

Do not turn the spiral cable using the airbag wire harness.

HINT:

The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.