Front Evaporator Temperature Sensor Installation

Install the No. 1 cooler thermistor as shown in the illustration.

NOTICE:

1. Be sure to insert the thermistor only once because reinserting it will not allow it to be firmly secured.
   
2. When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).
   
3. After inserting the thermistor, do not apply excessive force to the wire.
   
4. Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".
   

Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces. Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.

Compressor oil:

ND-OIL 8 or equivalent

NOTICE:

Keep the O-rings and O-ring fitting surfaces clean from dirt or foreign matter.

Install the No. 1 cooler evaporator sub-assembly together with the No. 1 cooler thermistor as a set.

Engage the clamp.

Engage the 4 claws as shown in the illustration.

Install the lower heater case with the 4 screws.

Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.

Torque:

3.5 N*m{36 kgf*cm, 31 in.*lbf}

Connect the connector.

Engage each clamp and install the air conditioning harness assembly.