Front Seat Assembly (For Manual Seat) -- Installation |
| 1. INSTALL FRONT SEAT ASSEMBLY |
Place the front seat assembly in the cabin.
- NOTICE:
- Be careful not to damage the vehicle body.
Connect the connectors under the seat.
Temporarily install the front seat assembly with the 4 bolts.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
Tighten the 2 bolts on the front side of the seat.
- Torque:
- 37 N*m{377 kgf*cm, 27 ft.*lbf}
- HINT:
- Tighten the bolts in the order indicated in the illustration.
 |
Lift up the seat track adjusting handle and move the seat to the foremost position.
Tighten the 2 bolts on the rear side of the seat.
- Torque:
- 37 N*m{377 kgf*cm, 27 ft.*lbf}
- HINT:
- Tighten the bolts in the order indicated in the illustration.
 |
| 2. INSPECT FRONT SEAT SLIDE ADJUSTER LOCK |
While sliding the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.
If the seat adjusters do not lock simultaneously, loosen the bolts securing the seat to adjust the adjuster position.
| 3. INSTALL INNER SEAT TRACK COVER |
Lift up the seat track adjusting handle and move the seat to the rearmost position.
Engage the 2 claws and install the inner seat track cover.
 |
| 4. INSTALL OUTER SEAT TRACK COVER |
Engage the 2 claws and install the outer seat track cover.
 |
| 5. INSTALL FRONT SEAT HEADREST ASSEMBLY |
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag) |
| 7. PERFORM REGISTRATION |
- HINT:
- If the occupant classification ECU has been replaced, perform registration (COROLLA_ZRE142 RM000001QX402OX.html).
| 8. ZERO POINT CALIBRATION AND SENSITIVITY CHECK |
- HINT:
- If the occupant classification ECU has been replaced, perform zero point calibration and sensitivity check (COROLLA_ZRE142 RM0000010VN07SX.html).
| 9. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag) |
- HINT:
- Inspect the SRS warning light (COROLLA_ZRE142 RM000000XFD0GSX.html).