Side Airbag Sensor (For Front Side) Installation

Check that the ignition switch is off.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

Insert the pin (stopper) into the door hole and install the door side airbag sensor to the front door panel with the bolt.

Torque:

9.0 N*m{92 kgf*cm, 80 in.*lbf}

NOTICE:

1. If the door side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
   
2. When installing the door side airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
   
3. Make sure that the pin (stopper) is securely inserted into the door hole.
   
4. Tighten the bolt while holding the door side airbag sensor because the door side airbag sensor pin (stopper) is easily damaged.
   

Connect the connector to the door side airbag sensor.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.

1. Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).
   
   

   
   
   
   
   

   Text in Illustration

   *1	White Housing Lock	*2	Yellow CPA
   *a	Connection is Completed	-	-

   HINT:

   When engaged, the white housing lock will slide. Be sure not to hold the white housing lock or part (A), as it may result in an insecure fit.

Check that there is no looseness in the installed parts of the door side airbag sensor.

Engage the front door trim board with the 5 claws on the front door inner glass weatherstrip.

Engage the 10 clips and install the front door trim board to the front door panel.

Install the 2 screws.

Engage the claw to install the door armrest cap.

Engage the 2 clips and 6 claws, and install the front armrest upper base panel.

w/ Power Door Lock:

1. Connect the connector.
   

Connect the connector.

Engage the 2 clips and 6 claws, and install the front armrest upper base panel.

Engage the 3 claws and install the front door inside handle bezel.

Temporarily install the front door window regulator handle assembly and fully close the window glass.

Install the front door regulator inside handle plate.

Install the snap ring to the front door window regulator handle assembly.

Install the front door window regulator handle assembly as shown in the illustration.