Curtain Shield Airbag Assembly Installation

Check that the ignition switch is off.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Install a new curtain shield airbag assembly with 5 new bolts.

Torque:

9.8 N*m{100 kgf*cm, 87 in.*lbf}

NOTICE:

1. If the curtain shield airbag assembly is removed, replace it with a new one.
   
2. Do not twist the curtain shield airbag assembly when installing it.
   

Install the 4 clips with the curtain shield airbag assembly to the body panel.

NOTICE:

Do not twist the curtain shield airbag assembly when installing it.

Install the 4 pins as shown in the illustration.

NOTICE:

Make sure that the pins of the clips are pushed in firmly.

Connect the curtain shield airbag connector.

NOTICE:

When connecting the airbag connector, take care not to damage the airbag wire harness.

Inspect the SRS warning light (COROLLA_ZRE142 RM000000XFD0GSX.html).