Entry Lock And Unlock Switch Installation

Insert the front end of the front door outside handle assembly into the front door outside handle frame.

Insert the rear end of the front door outside handle assembly into the front door outside handle frame. Next, slide the front door outside handle assembly toward the front of the vehicle to install it.

Connect the connector.

Engage the 2 claws and install the front door outside handle cover to the front door lock cylinder.

Install the front door lock cylinder.

HINT:

Make sure that the front door lock cylinder rod is inserted into the front door lock assembly.

Using a "TORX" socket wrench (T30), install the front door lock cylinder with the screw.

Torque:

4.0 N*m{41 kgf*cm, 35 in.*lbf}

Install the hole plug.

Apply butyl tape to the front door panel.

Pass the front door lock remote control cable and rear door inside locking cable through a new front door service hole cover.

Attach the front door service hole cover according to the reference points on the front door panel.

NOTICE:

Securely install the front door service hole cover preventing wrinkles and air bubbles.

w/ Power door lock:

1. Connect the connector.
   

Install the front door trim bracket with the 2 screws.

Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.

Engage the 2 claws and install the front door inside handle sub-assembly to the front door trim board.

Engage the front door trim board with the 5 claws on the front door inner glass weatherstrip.

Engage the 10 clips and install the front door trim board to the front door panel.

Install the 2 screws.

Engage the claw to install the door armrest cap.

Connect the connector.

Engage the 2 clips and 6 claws, and install the front armrest upper base panel.

Engage the 3 claws and install the front door inside handle bezel.