Engine Immobiliser System (W/O Smart Key System) Door Courtesy Switch Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH CIRCUIT)
INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
ENGINE IMMOBILISER SYSTEM (w/o Smart Key System) - Door Courtesy Switch Circuit |
DESCRIPTION
When an additional transponder key is registered, the transponder key ECU assembly detects the front door courtesy light switch open/close condition, and enters the key registration mode.
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU assembly is replaced, register the key and ECU communication ID (COROLLA_ZRE142 RM00000120Y02CX.html).
1.CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH CIRCUIT) |
Disconnect the transponder key ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
E21-7 (CTY) - Body ground
| Courtesy switch pushed (Door closed)
| 10 kΩ or higher
|
E21-7 (CTY) - Body ground
| Courtesy switch free (Door open)
| Below 1 Ω
|
2.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY |
Remove the driver side front door courtesy light switch (COROLLA_ZRE142 RM000002VPS00OX.html).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Switch Condition
| Specified Condition
|
1 - Switch body
| Courtesy switch pushed (Door closed)
| 10 kΩ or higher
|
1 - Switch body
| Courtesy switch free (Door open)
| Below 1 Ω
|
OK |
|
|
|
REPAIR OR REPLACE HARNESS OR CONNECTOR (TRANSPONDER KEY ECU - FRONT DOOR COURTESY LIGHT SWITCH) |
|