Rear Door Lock Removal

Using a clip remover, remove the snap ring.

Remove the rear door window regulator handle assembly and rear door regulator inside handle plate.

Using a moulding remover, disengage the 3 claws and remove the rear door inside handle bezel.

Using a moulding remover, disengage the 2 clips and 7 claws, and remove the rear door armrest upper base panel.

Using a moulding remover, disengage the 2 clips and 7 claws.

Disconnect the connector and remove the rear door armrest upper base panel.

Using a screwdriver with its tip wrapped with protective tape, disengage the claw and disconnect the door armrest cap.

Remove the 2 screws.

Using a clip remover, disengage the 8 clips.

Disengage the 4 claws and separate the rear door trim board sub-assembly from the rear door inner glass weatherstrip.

Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.

Disconnect the rear door lock remote control cable and rear door inside locking cable, and remove the rear door inside handle sub-assembly.

Remove the rear door inner glass weatherstrip from the rear door panel.

Remove the 2 screws and the rear door trim bracket.

w/ Power door lock:

1. Disconnect the connector.
   

Remove the rear door service hole cover.

HINT:

Remove any remaining butyl tape from the door.

Using a clip remover, disengage the 15 clips and remove the rear door weatherstrip.

Remove the rear door glass run.

Remove the 2 bolts, screw, and the rear door window division bar sub-assembly.

Remove the rear door quarter window glass and the rear door quarter window weatherstrip as a unit as shown in the illustration.

Remove the rear door quarter window glass from the rear door quarter window weatherstrip.

Remove the rear door glass sub-assembly from the rear door window regulator sub-assembly as shown in the illustration.

NOTICE:

Do not damage the door glass.

Using a "TORX" socket wrench (T30), remove the 3 screws.

Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.

Using a "TORX" socket wrench (T30), remove the 3 screws.

Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.

Remove the door lock wiring harness seal from the rear door lock assembly.

Remove the rear door lock remote control cable assembly.

Using a screwdriver, disengage the claw.

HINT:

Tape the screwdriver tip before use.

Remove the rear door lock remote control cable assembly.

Remove the rear door inside locking cable assembly.

Using a screwdriver, disengage the 3 claws.

HINT:

Tape the screwdriver tip before use.

Remove the rear door inside locking cable assembly.