Steering Angle Sensor (W/ Vsc) Installation

Align the 2 locating pins, engage the 6 claws, and install the steering angle sensor to the spiral cable.

Check that the front wheels are facing straight ahead.

Set the turn signal switch to the neutral position.

NOTICE:

If it is not in the neutral position, the turn signal switch pin may be snapped.

Install the spiral cable with steering angle sensor with the 3 claws.

NOTICE:

When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.

Connect the connectors to the spiral cable with steering angle sensor.

NOTICE:

When connecting the airbag connector, take care not to damage the airbag wire harness.

w/ Horn Button Wire Harness:

1. Connect the connector to install the horn button wire sub-assembly.
   

Engage the claw and the 2 pins, and install the upper steering column cover.

Engage the 2 claws to install the lower steering column cover.

Engage the 4 claws.

Engage the claw.

HINT:

Press the area around the claw to engage it.

Engage the 5 claws, 2 clips and 2 guides.

Install the lower instrument panel finish panel sub-assembly with the 2 screws <B>.

Check that the ignition switch is off.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Rotate the spiral cable counterclockwise slowly by hand until it stops.

NOTICE:

Do not turn the spiral cable using the airbag wire harness.

Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

NOTICE:

Do not turn the spiral cable using the airbag wire harness.

HINT:

The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.