Engine Switch -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| 2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH |
Disengage the 3 claws and clip, and then remove the lower instrument panel finish panel LH.
 |
| 3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH |
Apply protective tape to the area shown in the illustration.
 |
Insert a roof moulding remover and slide it toward the clip.
Pull the remover with both hands to disengage the clip as shown in the illustration.
Disengage the 2 claws and clip, and remove the instrument panel finish panel end LH.
 |
| 4. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
Operate the tilt lever to lower the steering wheel assembly.
Apply protective tape to the area shown in the illustration.
 |
Disengage the guide, claw and 3 clips, and then remove the instrument cluster finish panel assembly.
 |
| 5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Instrument Panel Under Cover) |
Disengage the 3 claws.
 |
Disengage the guide and remove the No. 2 instrument panel under cover sub-assembly.
| 6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
Remove the 2 screws <B>.
 |
Disengage the 5 claws, 2 guides and 2 clips, and then remove the lower instrument panel finish panel sub-assembly.
 |
| 7. REMOVE NO. 1 SWITCH HOLE BASE |
Disengage the 3 claws and clip.
 |
Disconnect the connector and remove the No. 1 switch hole base.
| 8. REMOVE ENGINE SWITCH |
Disengage the 2 claws and remove the engine switch from the No. 1 switch hole base.
 |