Air Fuel Ratio Sensor Removal

Remove the 2 front wiper arm head caps.

Remove the nut and the front wiper arm and blade assembly LH.

Remove the nut and the front wiper arm and blade assembly RH.

Disengage the 7 clips and remove the hood to cowl top seal.

Disengage the clip and 14 claws, and remove the center No. 1 cowl top ventilator louver.

Disengage the clip and 8 claws, and remove the cowl top ventilator louver LH.

Disconnect the connector.

Remove the 2 bolts and the windshield wiper motor and link assembly.

Disengage the clamp and bend the water guard plate RH as shown in the illustration.

Disengage the clamp.

Remove the 12 bolts and outer cowl top panel.

Disengage the clamp and bend the water guard plate RH as shown in the illustration.

Disengage the clamp and bend the No. 1 heater air duct splash shield seal.

Disengage the clamp.

Remove the 12 bolts and outer cowl top panel.

Hold the rear of the cover and raise it to disengage the 2 clips on the rear of the cover. Continue to raise the cover to disengage the 2 clips on the front of the cover to remove the cover.

NOTICE:

Attempting to disengage both front and rear clips at the same time may cause the cover to break.

Disconnect the air fuel ratio sensor connector and clamp.

Using SST, remove the air fuel ratio sensor.

SST

09224-00010