Can Communication System (For Rhd) How To Proceed With Troubleshooting

Check which of the following is adopted: SFI system, automatic transaxle system, brake control system, supplemental restraint system, air conditioning system and meter / gauge system (Link).

Check the CAN bus wires (CAMRY_ACV40 RM000000VYK01CX.html).

Select "Communication Bus Check" (CAMRY_ACV40 RM000000WIB040X.html).

Result:

Symptom	Proceed	See procedure
All the ECUs and sensors connected to the CAN communication system are displayed on the screen.	A	Go to step 5
An ECU or sensor not connected to the CAN communication system is displayed on the screen.	B	CAMRY_ACV40 RM000000WIB040X.html
More than one of the ECUs and sensors not connected to the CAN communication system are displayed on the screen. (If the displayed ECUs and sensors are only those relating to the "Engine" and "ECT", proceed to B.)	C	CAMRY_ACV40 RM000001ZSO00UX.html

NOTICE:

1. The systems (ECUs, sensors) that adopt CAN communication vary depending on the vehicle and option settings. Check which systems (ECUs, sensors) are installed on the vehicle (CAMRY_ACV40 RM000000WIB040X.html).
   
2. Non-installed ECUs or sensors are not displayed. Do not mistake ECUs that are not installed as being in communication stop mode.
   
3. If 2 or more ECUs or sensors are not displayed on the intelligent tester, perform troubleshooting for communication stop mode for each undisplayed ECU or sensor. (Open in one side of the CAN branch wires.)
   

Confirm trouble according to the combination of output DTCs regarding the CAN communication system (CAMRY_ACV40 RM000000WIB040X.html).

HINT:

Previous CAN communication system DTCs may be the cause if CAN communication system DTCs are output and all ECUs and sensors connected to the CAN communication system are displayed on the intelligent tester "Communication Bus Check" screen.