Can Communication System (For Rhd) Precaution

Care must be taken when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazardous driving.

This vehicle is equipped with an SRS (Supplemental Restraint System) which includes parts such as the driver airbag and front passenger airbag. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may lead to a serious accident. Before servicing (including removal or installation of parts, inspection or replacement), be sure to read the precautionary notice for the Supplemental Restraint System (CAMRY_ACV40 RM000000KT1016X.html).

After repairing a bus wire with solder, wrap the repaired part with vinyl tape.

NOTICE:

1. The CANL bus wire and CANH bus wire must be installed together at all times.
   
2. When installing, make sure that they are twisted.
   
3. CAN bus wires are likely to be influenced by noise if the bus wires are not twisted.
   
4. The difference in length between the CANL bus wire and CANH bus wire should be within 100 mm (3.937 in.).
   
5. Leave approximately 80 mm (3.150 in.) loose in the twisted wires around the connector.
   

Do not use bypass wiring between the connectors.

NOTICE:

The protective effect of the twisted wire harness will be lost if you use bypass wiring.

When checking resistance with a tester, insert the tester probes from the backside (harness side) of the connector.

Use a service wire to check the connector if it is impossible to check continuity from the rear of the connector.