Can Communication System (For Lhd) Can Bus Line

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK CAN BUS WIRE (MAIN BUS WIRE FOR DISCONNECTION, BUS WIRES FOR SHORT CIRCUIT)

CHECK CAN BUS WIRE (SHORT TO B+ IN CAN BUS WIRE)

CHECK CAN BUS WIRE (SHORT TO GND IN CAN BUS WIRE)

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:

1. Turn the ignition switch off before measuring the resistance of the CAN main wire and CAN branch wires.
   
2. After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
   
3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
   

HINT:

Operating the ignition switch, any other switches or any triggers related ECU and sensor communication on the CAN, which would cause resistance reading variations.

1. Measure the resistance according to the value(s) in the table below.
   

   Standard resistance:

   Tester Connection	Condition	Specified Value	Result
   E10-6 (CANH) - E10-14 (CANL)	Ignition switch off	54 to 69 Ω	OK

   Result:

   Result	Proceed to
   OK	A
   70 Ω or higher	B
   Below 54 Ω	C

1. Measure the resistance according to the value(s) in the table below.
   

   Standard resistance:

   Tester Connection	Condition	Specified Value
   E10-6 (CANH) - E10-16 (BAT)	Ignition switch off	6 kΩ or higher
   E10-14 (CANL) - E10-16 (BAT)	Ignition switch off	6 kΩ or higher

1. Measure the resistance according to the value(s) in the table below.
   

   Standard resistance:

   Tester Connection	Condition	Specified Value
   E10-4 (CG) - E10-6 (CANH)	Ignition switch off	200 Ω or higher
   E10-4 (CG) - E10-14 (CANL)	Ignition switch off	200 Ω or higher